Technical Information

Installation of the blanket is pretty straightforward and should not take long depending on your application.

Use these instructions to help you install flat turbo blanketing. Wear gloves!

You’ll need a flexible measuring tape for this installation. With a few measurements and a little work you’ll have your starter shield installed in no time.

Remove the turbo blanket from the packing and prepare your engine bay for installing the blanket (i.e. move anything you can away from the turbo so you can get full access to it).

Our ties normally do not require any tools to install them properly but here are a few tips to make your installation procedure go a bit easier.

Wrapping a pipe properly can be very time consuming to make it look good, so take your time and don’t get frustrated! Just make sure your wraps are tight and even for the best appearance.

Our premium turbo shields are extremely easy to install on the turbo itself although in some cases you may have to remove things in order to gain clear access to the turbo’s exhaust side.

Our premium turbo shields are extremely easy to install on the turbo itself although in some cases you may have to remove things in order to gain clear access to the turbo’s exhaust side.

The Arctic Cat manifold blanket kit includes 3 pieces. A top blanket (3 sided), bottom blanket and a flange ring blanket.

Heat sheathing may seem like a very easy item to install, which it is. However here is a short tutorial with some tips included to make sure your sheathing installs holds up the way it should.